Mat.No. 1.1223, DIN CM60, AISI 1060
Designation by Standards Mat. No. DIN EN AISI 1.1223 Cm60 - 1060 Chemical Composition (in weight %) C Si Mn Cr Mo Ni V W Others 0.61 max. 0.40 0.75 max. 0.40 max. 0.10 max. 0.40 - - (Cr+Mo+Ni) = max. 0.63 Description CM60 is one of the higher carbon content (0.60%) steels. It is more difficult to fabricate than the lower carbon grades. Applications Shafts, bushings, connecting rods, nechanical engineering components, agricultural hand tools, ...
Detalle del producto
Preguntas más frecuentes
Etiquetas de productos
Designación por las Normas
Composición química (en% en peso)
|0.61||máx. 0.40||0.75||máx. 0.40||máx. 0.10||máx. 0.40||-||-||(Cr + Mo + Ni) = max. 0.63|
Descripción CM60 is one of the higher carbon content (0.60%) steels. It is more difficult to fabricate than the lower carbon grades. Las solicitudes Shafts, bushings, connecting rods, nechanical engineering components, agricultural hand tools, large forgings, springs, cold rolled strips. Las propiedades físicas (valores avarage) a temperatura ambiente Modulus of elasticity [103 x N / mm 2]: 210 Density [g/cm3]: 7.85 El recocido suave Heat to 650-700o C, cool slowly in furnace. This will produce a maximum Brinell hardness of 241. La normalización de Normalizing temperature: 820-850o C.Endurecimiento Harden from a temperature of 800-830o C, 810 a 840 o C followed by water or oil quenching. Templado Tempering temperature: 540-680o C.La forja Hot forming temperature: 1100-850o C.Maquinabilidad Machinability of CM60 and all of the higher carbon steels is relatively poor. CM60 rates at 55 to 60 % that of the AISI 1112 steel which is considered 100% machinable. Resistencia a la corrosión This steel is not corrosion resistant. it will rust unless protected. Soldadura CM60 steel is weldable by all of the welding methods. However with its higher carbon content it is important to use both pre-heat at 150 to 260o C y post-calor a 590 a 650 o C practice per an approved welding procedure. Trabajo en frío Cold working is difficult even in the annealed condition although it may be done by conventional methods but requires greater force than the lower carbon steels. Forms manufactured: Please see the Dimensional Sales Program. Exención de responsabilidad The information and data presented herein are typical or average values and are not a guarantee of maximum or minimum values. Applications specifically suggested for material described herein are made solely for the purpose of illustration to enable the reader to make his own evaluation and are not intended as warranties, either express or implied, of fitness for these or other puposes. There is no representation that the recipient of this literature will receive updated editions as the become available. Unless otherwise specified, registered trademarks are property of Metal Ravne company. Copyright 2015 by Metal Ravne. All rights reserved. Contact our Sales Office for more information.