DIN 100V1, AISI W2
Designation by Standards Mat. No. DIN EN AISI - 100V1 - W2 Chemical Composition (in weight %) C Si Mn Cr Mo Ni V W Others 1.02 0.20 0.23 - - - 0.10 - - Description Low alloyed water-hardening tool steel. Applications Cold working tools for steels and metals when hard surface and tough core are demanded – tap drills, dies, broaching tools, stone working tools. Physical properties (avarage values) at ambient temperature Modulus of elastic...
Designation by Standards
Chemical Composition (in weight %)
Low alloyed water-hardening tool steel.
Cold working tools for steels and metals when hard surface and tough core are demanded – tap drills, dies, broaching tools, stone working tools.
Physical properties (avarage values) at ambient temperature
Modulus of elasticity [103 x N/mm2]: 210
Density [g/cm3]: 7.85
Thermal conductivity [W/m.K]: 45.0
Electric resistivity [Ohm mm2/m]: 0.20
Specific heat capacity[J/g.K]: 0.46
Coefficient of Linear Thermal Expansion 10-6 oC-1
Heat to 680-720oC, cool slowly. This will produce a maximum Brinell hardness of 213.
Stress relieving to remove machining stresses should be carried out by heating to approx. 600-650oC, holding for 1-2 hours at heat, followed by air cooling. This operation is performed to reduce distortion during heat treatment.
Harden from a temperature of 760-800oC followed by water quenching. Hardness after quenching is 65 HRC.
Tempering temperature: See the data bellow.
Tempering Temperature (oC) vs. Hardness (HRC)
Hot forming temperature: 1000-800oC.
The information and data presented herein are typical or average values and are not a guarantee of maximum or minimum values. Applications specifically suggested for material described herein are made solely for the purpose of illustration to enable the reader to make his own evaluation and are not intended as warranties, either express or implied, of fitness for these or other puposes. There is no representation that the recipient of this literature will receive updated editions as the become available.